10G-LR 1310nm SM LC Duplex SFP+ Transceiver with DDM – 10KM – FSPP-H7-S13-10D

• Compliant with IEEE802.3ae 10GBASE-LR/LW
• Compliant with CPRI Option 7, 8
• Compliant with SFF-8431 SFP+ MSA
• Support 8.5Gb/s to 11.32Gb/s Multi-Rate
• Hot Pluggable
• 1310nm DFB laser transmitter
• Duplex LC connector
• 2-wire interface for management and diagnostic monitor compliant with SFF-8472
• Single +3.3V power supply
• Link distance 10km over SM fiber
• RoHS Compliant

Compare Compare

FSPP-H7-S13-10D Small Form Factor Pluggable SFP+ transceivers are compliant with the current SFP+ Multi-Source Agreement (MSA) Specification. The high performance uncooled 1310nm DFB transmitter and high sensitivity PIN receiver provide superior performance for 10GBASE-LR/LW applications up to SMF 10km optical links.

Absolute Maximum Ratings

Parameters Symbol Min. Max. Unit
Storage Temperature TST -40 +85 °C
Storage Relative Humidity RH 5 95 %
Supply Voltage VCC -0.5 +4.0 V

Recommended Operating Conditions

Parameters Symbol Min. Typ. Max. Unit
Case Operating Temp. (FSPP-H7-S13-10D) TOP 0 +70 °C
Case Operating Temp. (FSPP-H7-S13-10Di) TOP -40 +85 °C
Supply Voltage VCC +3.13 +3.3 +3.47 V
Supply Current (FSPP-H7-S13-10D) ICC 320 mA
Supply Current (FSPP-H7-S13-10Di) ICC 350 mA

Transmitter Electro-optical Characteristics

VCC= 3.13V to 3.47V, TOP = 0 °C to 70 °C(FSPP-H7-S13-10D); TOP = -40 °C to 85 °C(FSPP-H7-S13-10Di)

Parameters Symbol Min. Typ. Max. Unit Note
Operating Data Rate DR 8.5 10.3125 11.32 Gb/s
Optical Launch Power Po -8.2 +0.5 dBm 1
Optical Center Wavelength λc 1260 1310 1355 nm
Spectral Width (-20dB) Δλ 1 nm
Side Mode Suppression Ratio SMSR 30 dB
Optical Extinction Ratio ER 3.5 dB
Optical Eye Mask IEEE802.3ae
Relative Intensity Noise RIN -128 dB/Hz
Differential Data Input Swing VIN 180 850 mV
TX Disable Input Voltage-Low (TX ON) TDISVL GND 0.8 V
TX Disable Input Voltage-High (TX OFF) TDISVH 2.0 Vcc V
TX Fault Output Voltage-Low (TX Normal) TFLTVL GND 0.8 V
TX Fault Output Voltage-High (TX Fault) TFLTVH 2.0 Vcc V

Note1: The optical power is launched into a 9/125μm single mode fiber.

Receiver Electro-optical Characteristics

VCC= 3.13V to 3.47V, TOP = 0 °C to 70 °C(FSPP-H7-S13-10D); TOP = -40 °C to 85 °C(FSPP-H7-S13-10Di)

 

Parameters Symbol Min. Typ. Max. Unit Note
Operating Data Rate DR 8.5 10.3125 11.32 Gb/s
Receiver Sensitivity SEN -14.5 dBm 1
Maximum Receive Power PRX-MAX +0.5 dBm 1
Optical Center Wavelength λc 1260 1620 nm
LOS De-Assert LOSD -15.5 dBm
LOS Assert LOSA -30 dBm
LOS Hysteresis LOSHY 0.5 dB
Differential Data Output Swing VOUT 300 900 mV
Receiver LOS Signal Output Voltage-Low LOSVL GND 0.8 V
Receiver LOS Signal Output Voltage-High LOSVH 2.0 Vcc V

Note1: Measured with a PRBS 231-1 test pattern @10.3125Gbps BER<10-12.